Apr 01, 2020

Geotextile to repair old asphalt pavement

Leave a message

Old pavement treatment

1. The old pavement should be cleaned of dust, loose particles and debris, cleaned, and the surface kept dry. Scrape the sharp and abrupt parts of the road surface; when the road surface is seriously damaged or broken, the broken parts should be removed and repaired with asphalt concrete. For pavements with severe cracks or ruts, a leveling layer of 1 to 2 cm needs to be filled.


2. Spread asphalt sticky layer oil

When using liquid petroleum asphalt for sticky layer oil, the atmospheric temperature is above 5 ℃; when using emulsified asphalt for sticky layer oil, the atmospheric temperature is above 10 ℃. No sticky layer of oil should be poured when the road surface is wet on rainy days and after rain. Attention should be paid to choosing the type and amount of sticky layer oil. Practice has proved that it is best to use EVA or SBS modified asphalt, these products have good crack resistance and thermal stability. If emulsified asphalt is used, its asphalt content must be greater than 60% to be well utilized.


Before laying the geotextile, sprinkle the bituminous sticky layer, the dosage is about 0 · 4 ~ 0 · 6kg / m2, then lay the geotextile, and then spray another layer of the same type of sticky layer oil on the geotextile, the dosage is about 0・ 5 ~ 0 ・ 6kg / m2. The following points should be noted: (1) It is recommended to use hot asphalt sticky sleeves, and the oil temperature should be maintained between 150 and 170 ° C; The oil spraying should be even and the measurement must be accurate.


If one-time oil pouring is used, the total amount of sticky layer oil cannot be reduced. The recommended value is 1 · 0 ~ 1.3kg / m2, and the oil temperature cannot be lower than 180 ℃. One-time oil pouring is prone to impermeability of geotextiles and delamination, leading to peeling of the surface layer.


Send Inquiry